Compuprint SP40 Bedienungsanleitung PDF herunterladen (Seite 33)

Setup Parameters

The following is a listing of the setup parameters.

Configuration Sheet

Setup Parameter Values Description

RESTORE TO MFG no

all

config

prog. 1,

prog. 2

The selected values are not set to factory defaults.

The values set in all printer setups are reset to factory default

values.

The values set in the configuration setup are reset to factory

default values.

The values set in the corresponding program setup are reset to

the factory default values.

RIBBON REPLACED yes

Sets the ribbon life counter to zero .

Leaves the ribbon life counter at the current state

PROGRAM progr. 1,

progr. 2,

on interface

Defines the default Program Setup. Selecting progr.1 or

progr.2 the setup parameters set in the corresponding

Program Setup are set. Selecting on interface the printer

matches the Program 1 settings with the data arriving on the

Centronics interface, and the Program 2 settings with the data it

receives from the serial interface. When changing from one

interface to the other, the default values are set for the

corresponding Program Setup.

ERROR BUZZER enable, disable Enables or disables the buzzer in case of an error.

JOB BUZZER no beep,

1 beep, continuous

Selects the behavior of the buzzer when a new print job starts:

no signal (no beep), one beep (1 beep) or a continuous signal

(continuous).

INTERFACE TYPE parallel, serial, lan*,

Selects the interface type. Selecting ‘automatic’ the interface

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 71 72

Keine Kommentare

Compuprint SP40 Bedienungsanleitung Seite 33