Compuprint 9058 Programmer Manual Bedienungsanleitung PDF herunterladen (Seite 133)

The Parallel Interface

A78408098-003

C.4

Parallel Interface Signals

Description of the signals in monodirectional link:

Signal

Name

Pin N° Source Description

STROBE 1 HOST Clock signal which controls data

transmission with its falling edge.

ACK 10 PRINTER Negative pulsed signal indicating that the

printer has received data and is ready to

accept the next set of data. Also sent

when the printer is switched from off-line

to on-line and at the end of the

initialization time. The BUSY line is

always active.

DATA BIT 1

DATA BIT 2

DATA BIT 3

DATA BIT 4

DATA BIT 5

DATA BIT 6

DATA BIT 7

DATA BIT 8

PRINTER / HOST Data 8 is the most significant bit. These

are the data lines used by host or printer

to transfer control code or ASCII codes

BUSY 11 PRINTER When high, this signal indicates that the

printer cannot accept data or control

codes. This signal goes high during data

processing, in test and program modes,

during initialization, when the buffer is

full, and when a paper jam, paper end or

paper size error occurs, in case of a

power-on reset, the reception of a

STROBE signal, while the register was

not yet read, or when the INIT line is still

active

PE 12 PRINTER When high, this signal indicates that the

automatic input bin is out of paper and

paper cannot be loaded from an other

bin

SELECT 13 PRINTER When high, this signal indicates that the

printer is on-line. It is put to low state in

case of initialization or test and program

mode. In IBM Proprinter emulation in low

condition this signal signals a off-line

request from the operator panel, paper

jam, paper end or paper size errors.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 142 143

Kommentare zu diesen Handbüchern

Keine Kommentare

Compuprint 9058 Programmer Manual Bedienungsanleitung Seite 133

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucker Compuprint 9058 Programmer Manual