Compuprint 9058 Programmer Manual Bedienungsanleitung PDF herunterladen (Seite 20)

EPSON/IBM Mode

A78408098-003

If the top margin set via operator panel is greater than the skipover

value, then the following value of the margins will be set:

Top margin = skipover value

Bottom margin = 0

If the top margin set via operator panel is less or equal to the

skipover value, then the following value of the margins will be set:

Top margin = operator panel value

Bottom margin = the difference between skipover value and

top margin value

If the sum of the top and bottom margins values set via operator

panel is less than the skipover value, the following values for the

margins will be set:

Top margin = operator panel value

Bottom margin = the difference between skipover value and

top margin value

Changing the vertical spacing does not affect the skipover distance. This

can be changed by a further ESC N command or can be reset by the ESC

O command, which resets the skipover value to 0. The skipover

perforation will be executed when the end of the page is reached with a

LF, VT or FF code and not with the ESC J or ESC C command, the

skipover perforation is cancelled and must therefore be set again.

ESC O

Disables the skipover perforation. (IBM, EPSON)

ASCII Code ESC 0

Hexadecimal Value 1B 4F

Decimal Value 27 79

This sequence sets the number of lines of the skipover perforation to

the value 0 and so any skip perforation set by ESC N is cancelled.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 142 143

Keine Kommentare

Compuprint 9058 Programmer Manual Bedienungsanleitung Seite 20