Compuprint MDP40B Programmer Manual Bedienungsanleitung PDF herunterladen (Seite 34)

A-32

Changing the vertical spacing does not affect the skipover distance. This can be

changed by a further ESC N command or can be reset by the ESC O command, which

resets the skipover value to 0. The skipover perforation will be executed when the end

of the page is reached with a LF, VT or FF code and not with the ESC J or ESC C

command, the skipover perforation is cancelled and must therefore be set again.

In IBM 4722 and 9068 emulations, this command is recognized and discarded.

ESC O

Disables the skipover perforation.

(IBM Proprinter XL24/XL24E, 2391+, EPSON ESC/P2)

ASCII Code ESC 0

Hexadecimal Value 1B 4F

Decimal Value 27 79

This sequence sets the number of lines of the skipover perforation to the value 0 and

so any skip perforation set by ESC N is cancelled.

In IBM 4722 and 9068 emulations, this command is recognized and discarded.

ESC Q

Sets the right margin (10 cpi). (EPSON ESC/P2)

ASCII Code ESC Q

Hexadecimal Value 1B 51

Decimal Value 27 81

Range 1 <

< 255

This code sets the line length at the current horizontal spacing. It must be sent at the

beginning of the line. The n parameter specifies the number of columns and for each

type of horizontal spacing there is a range of values, as shown in the following table:

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 288 289

Keine Kommentare

Compuprint MDP40B Programmer Manual Bedienungsanleitung Seite 34